Posted by Vaughn [172.71.154.202] on Saturday, November 30, 2024 at 15:08:52 :
In Reply to: Re: Poly/LA water pump for PW conversions posted by Kaegi [162.158.41.87] on Thursday, November 28, 2024 at 19:11:16 :
The only high riser I've seen is for the SBC, the mounting holes even at the block of a SBM are not the same as a SBC. The width between the two bank water holes might be the same but drilling new holes would be required even if it was possible. Maybe at some point they were made for the SBM but today it's only the SBC. If I was going to consider a Mopar swap, I would look seriously at the 340 engine where the water pump entry is on the correct side for the PW radiator. I don't know if the 340 pump will bolt up to a 318/360 engine, it has less holes than a 318/360, but who knows.
Follow Ups: